How to run BMW ICOM A2 with E-SYS?

It is possible use the bmw icom a2 francais to work in the e-sys??

Yes, just lock it with EasyConnect, obd_ab625 and then insert your ICOM IP in ESYS connection manager.

Here are the steps:

You have to lock/check the ICOM IP in ISTA-Dso E-Sys can use it. Therefore you need a tool like EasyConnect or iToolRadar. 

Connect the ICOM, turn the ignition on, start f.e. iToolradar. Now you can see the connection from the ICOM (normally on 169.154.92.38), mark it and click on reserve

(in EasyConnect is different but as easy as itoolradar).

Start E-Sys, choose the target (f.e. F010) and click on "connection ICOM/Ethernet". Type the IP address (here 169.254.92.38), the port is 50160, so the result should be tcp://169.254.92.38:50160.

Connect and have fun.

Note: TRY ON YOUR RISK. The instruction via pictures is kind of different that via words, especially ICOM IP setup. Both can be tried.

Feedback on ICOM connection to E-sys

My experience says that you need patience to use a icom diag head with e-sys, it's a 50/50 chance that it will work or not, or, something may not work. Last time I had a problem that I could code a lot of modules, except the BKOMBI module was uncodable (it gave a error on coding, don't know what type of error).