Here is the
detail instruction on how to program EEPROM with digiprog 3 odometer correction tool through “EEPROM” menu.
On some vehicles you can see an eight pin EEPROM chip which is used
to store the vehicle data and these chips grasp vital information from the
vehicle such as ignition and immobilizer codes. Once you lose those data, it
may cause anything from minor fault to major faults and even make you have to
repair your machine, so it is very important to use the digiprog3 “EEPROM” menu to read and
save the original information.
The EEPROM chip would
have a number on the top of itself and usually it will be “93C46″, you can
connect it to your digiprog III via ST1 or ST4 adaptor.
Then you should tell your digiprog III which chip you are working on before you
use it to read.
How to program EEPROM using digiprog 3 mileage correction kit?
1.
De-solder EEPROM chip;
2.
Confirm the contact points or
legs with glass fiber pin thoroughly;
3.
Clean clearly with sandpaper;
4. Insert
EEPROM correctly into Digiprog3 ST01/ST04 adapter,
and make sure they are well contacted;
5.
Connect DP3 device to your car via OBD connector
6. Enter
“EEPROM” menu
7. Read data from EEPROM and store them in digiprog3; Follow this way:
Select the “SET TYPE” and choose “93C46″, then your digiprog has been
set up to read a 93C46 chip. Press “EEPROM” again and then “READ”. There will
show you the information on the digiprog III screen when the reading is
complete. Now press “VERIFY” so the information on your screen can agree with
the Eeprom.
Next click the “FILE” and there will show
you another sub-menu, you can click “SAVE” and enter a file name for the
information you are saving. Once you entered the file name, your data is safe
and the vehicle is now ready to be reprogrammed.
8. Get EEPROM from ST01/ST04 adapter and reload it;
9. Select the function EEPROM COMPARE;
10. Then it is the previous read data on digiprog 3 but not the internal
memory, comparing it with the now re-inserted EEPROM;
NOTE:
Error message may appear during the
process, restore or reprogram, restore the original data status and it will be
fixed.
Apart from DigiProg 3 “EEPROM” Menu,
it also have “CAR/TRUCK” Menu, “Motorcycle” Menu, “Special
Functions” Menu and “Setup” Menu.
More
Digiprog 3 main unit and cables information, please check here:
没有评论:
发表评论