KESS V2 is a ECU programming tool that is perfect for OBD use, With KESS V2 you programming directly through the OBD port of the vehicle. Many ECU has the advantage that can be read and write from OBD port (so KESS V2 is perfect).
If you want to make a full BDM read, recommend you use Ktag SW V2.13 FW V6.070. KTag is perfect for Jtag, BDM and all the Boot application (tricore and ST10), with Ktag you need to take apart the ECU and open it, after you can make the read/write operation. There are lot ECU that need to disassemble from the car and open and this is the case for all the ECU that need to be programmed withJtag, BDM and Boot protocols, so KTAG is needed.
FGTECH Galletto is advanced ECU programmer, it reads and writes the Engine ECU data via BDM, OBD and tricore. It covers Motorcycle that KESS V2 and KTAG can't do, and fgtech is no token limitation.
Where to buy KESS V2, KTAG and Fgtech?
I strongly recommend you www.obd2france.com who has been dealing with these tools for many years so the quality and price trustful.
I take the several version of KESS V2, KTAG and FGTECH PCB for example, since there are available multi-versions and with different PCB.
Seeing is believing!
This is KESS V2 firmware V4.036 PCB.
This is Ktag firmware V6.070 PCB.
This is FGTech Galletto V54 PCB
I think the essential differences among KESS V2, KTAG, FGTECH V54 are listed above, hope it helps.
没有评论:
发表评论